What do parameters like Ah (Ampere-Hour) mean for ebikes?
It’s the current capacity of the battery. The maximum current the battery can be discharged at continuously for 1 hour. For example; you can draw 10A continuously from a 10Ah battery for 1 hour or 5A for 2 hours.
This is a parameter that gives you a range. However, the energy density of a battery should be measured by Wh(watt-hour) if you are comparing battery systems of different voltage. Ah increase when using higher capacity Li-Ion cells or using more Li-Ion cells in parallel in a battery pack.
We're Happy to help:
Still can't find the solution?
Or
2. Connect with our agents through live chats 
Related Articles
What do parameters like Ah (Ampere-Hour) mean for ebikes?
It’s the current capacity of the battery. The maximum current the battery can be discharged at continuously for 1 hour. For example; you can draw 10A continuously from a 10Ah battery for 1 hour or 5A for 2 hours. This is a parameter that gives you a ...What do parameters like Ah Wh (Watt-Hour) mean for ebikes?
It’s the energy capacity of battery. Wh=Ah x V. For example a 48V, 8.8Ah battery gives you 48V 8.8Ah = 422.4Wh energy which ideally means you can draw 422W power for 1 hour. The equivalent battery in 36V standard will be about 11.7AhWhat do parameters like Torque (Nm) mean for ebikes?
Motor Torque is the characteristic which reflects the traction (thrust) and is important for climbing up hills. The traction force equals Torque divided by wheel radius (F=T/R). The more torque at the wheel gives you a higher grade-ability. The ...What do parameters like Power W (Watt) mean for ebikes?
The amount in Watts shows the power (P) of motor. The power is important for riding faster both on flat or slope. There is a rated power definition for electric motor, which is the nominal power that the motor is designed to work to deliver ...What do parameters like V(Volt) mean for ebikes?
Power equals Voltage by Current: The higher the voltage, lower current is necessary to get the same amount of power (P=VI). The voltage should be managed by compromising safety and current rating of component. This is a parameter which is set based ...