Error info 4 - torque sensor abnormality
If you are facing the error 4 on your LCD3 Display please follow the following troubleshooting advice and hopefully it will resolve the issue.
- Check PAS sensor on the crankshaft, as you rotate the
pedals the LED should blink.
- See the alignment of the disk to the sensor, the gap
between sensor and disk should be 1-2mm and should maintain that distance.
- Look for the wire damage and dirt accumulation.
We're Happy to help:
Still can't find the solution?
Or
2. Connect with our agents through live chats 
Related Articles
Error info 5 - speed sensor abnormality
If you are facing the error 5 on your LCD3 Display please check for motor cables which might be damaged.Error info 2 - motor hall sensor abnormality
If you are facing the error 2 on your LCD3 Display please check for motor cables from wheel axel which might be damaged. Check for any kind of stretch wires or damaged cables from motor to controller and replace the wire if you see any damage.Error info 1 - throttle abnormality
If you are facing the error 1 on your LCD3 Display please follow the following troubleshooting advice and hopefully it will resolve the issue. - Make sure the throttle level is in ideal state and don’t apply throttle while booting up system. - Check ...Is torque sensor pedal assist system (PAS) better than motion sensor?
Generally speaking torque sensor is a more sophisticated technology which is getting a good performance and feedback on electric bikes such as those integrated with Bosch, Shimano or Yamaha ebike motor systems. Torque sensor should have an integrated ...0x25 Torque signal error (related to brake/throttle/PAS) on 750C
This error usually happens when brake/throttle applied and then turning on the bike. Keep the brake/throttle/pas in ideal condition don’t apply brake or throttle and let the system completely bootup.