Error info 2 - motor hall sensor abnormality

Error info 2 - motor hall sensor abnormality

If you are facing the error 2 on your LCD3 Display please check for motor cables from wheel axel which might be damaged. Check for any kind of stretch wires or damaged cables from motor to controller and replace the wire if you see any damage. 




    We're Happy to help:

    Still can't find the solution?

    1. Please fill up the support form at the link below:
    ​
                      
           
                                      Or
    2. Connect with our agents through live chats  

      • Related Articles

      • Error info 5 - speed sensor abnormality

        If you are facing the error 5 on your LCD3 Display please check for motor cables which might be damaged.

      • Error info 4 - torque sensor abnormality

        If you are facing the error 4 on your LCD3 Display please follow the following troubleshooting advice and hopefully it will resolve the issue. - Check PAS sensor on the crankshaft, as you rotate the pedals the LED should blink. - See the alignment of ...

      • Error info 1 - throttle abnormality

        If you are facing the error 1 on your LCD3 Display please follow the following troubleshooting advice and hopefully it will resolve the issue. - Make sure the throttle level is in ideal state and don’t apply throttle while booting up system.  - Check ...

      • 0x08 Hall error code on 750C

        Check the condition of the motor to controller cable, check for any wear/tear.

      • Error info 6 - motor /controller cable short circuit

        When wires are looped in the same place or zip tie is tighten too much, then in overload condition the wires may get heated and might get damage. This can be observer from controller side. Please check the cable and let us know.