Display question, if I set 0 as the assist level and turn off the display is it normal that when I turn it back on it defaults to 1?
This is a standard setting you change on you r display to land on a certain level whenever you start up or keep the last one used.
Please refer to the display manual of your system.
We're Happy to help:
Still can't find the solution?
Or
2. Connect with our agents through live chats 
Related Articles
Every time I restart the ebike the display clock needs re-set
ENVO D35/ST 750C DISPLAY CLOCK RESET GUIDE. In order to keep the clock working for a longer period of time after switching off the system, the display internal battery needs some time to get charge when the system is ON. This can normally happen if ...C961 Display Manual
.System does not turn on
System does not turn on Connections are not completed Do a thorough check from battery power lines to controller and all other connectors Battery is turned off Turn battery on using the on/off switch on the battery Battery is dead See if battery ...Is torque sensor pedal assist system (PAS) better than motion sensor?
Generally speaking torque sensor is a more sophisticated technology which is getting a good performance and feedback on electric bikes such as those integrated with Bosch, Shimano or Yamaha ebike motor systems. Torque sensor should have an integrated ...After 5 hours charge, the LCD display is still showing half battery. Is something wrong with battery or charger?
The display charge indicator has a lagging system so that it’ll stabilize in cases of voltage fluctuations. Switch the bike ON Ride for 10-15 sec, and the bars will show full. At no load condition ~42V is fully charged ~32V is fully discharged. You ...